Skip to content
Staff

Tesla Powerwall 3 course bundle receives SAA CPD accreditation

Tesla's Powerwall 3 Course Bundle is now an SAA accredited course worth 10 CPD points, and covers the Powerwall 2 compatibility firmware rollout.

Three installers in high-visibility polos standing beside a newly installed wall-mounted Tesla Powerwall

Tesla has confirmed that its Powerwall 3 Course Bundle is now an accredited course under Solar Accreditation Australia, carrying 10 CPD points. Product training that previously counted only as internal certification now contributes to the accreditation an installer has to maintain regardless.

Ten CPD points

Solar Accreditation Australia requires accredited installers and designers to complete 100 CPD points every 12 months on a rolling basis. Points totals and due dates are visible to each accreditee in the SAA Portal. Mandatory modules covering standards and regulatory changes sit within that total rather than on top of it.

The Powerwall 3 Course Bundle contributes 10 points against that annual requirement.

Claiming the points

Tesla has set out three steps:

  1. Complete the online Powerwall 3 Course Bundle.
  2. The certificate is emailed to the address registered against the Tesla login on the Monday after the bundle is completed.
  3. Upload that certificate to the SAA Portal to have the 10 points recorded.

The points are not applied automatically. The certificate has to be uploaded by the accreditee, and the Monday issuing cycle means a bundle finished mid-week will not produce a certificate until the following week. Anyone working to a CPD due date should allow for that gap.

Powerwall 2 course content

The bundle carries the current Powerwall 3 material, including the compatibility pathway that has moved from pilot arrangement to official release. Powerwall 3 works with an existing Powerwall 2 system through firmware version 26.26. Tesla has begun the official rollout and it becomes standard at commissioning from mid-August, with installations continuing under pilot firmware until then.

The technical conditions, including gateway exclusions and the output limit that applies on three-phase sites, are set out in Powerwall 3 compatibility with existing Powerwall 2 systems. The rollout timing is covered in the firmware rollout bulletin.

Product approval

Tesla has now given the specific position on Powerwall 2 and the Clean Energy Council approved product list, which had previously been described only in general terms.

Powerwall 2 remains unlisted on that list following the expiry of its listing in August 2025. Tesla states that re-certification is not planned, because the product is being sunset and because of the updated requirements in AS/NZS 4777.2:2020 Amd 2:2024, which took effect on 23 August 2025.

The Clean Energy Council's own position on that amendment is consistent. It was published in August 2024 with a 12-month transition, took effect on 23 August 2025, and any relevant inverter for which the manufacturer did not provide a compliance declaration was removed from the approved list on that date.

AS/NZS 4777.2 amendment transition
Data to
AS/NZS 4777.2 amendment transitionTimeline from 1 July 2024 to 31 Dec 2025. Clean Energy Council 12-month transition. Select an event to inspect its date. Dashed bands are approximate.1. Clean Energy Council 12-month transition1 July 202431 Dec 2025
  1. 1Clean Energy Council 12-month transition1 Aug 2024 to 23 Aug 2025 · approximate period
23 Aug 2025 · Amd 2:2024 takes effect

The transition band starts at the published month because the Clean Energy Council does not state a publication day. The 23 August 2025 effective date, on which inverters lacking a manufacturer compliance declaration were removed from the approved list, is exact.

Data table
Data for AS/NZS 4777.2 amendment transition
EventFromToPrecision
Clean Energy Council 12-month transition1 Aug 202423 Aug 2025Approximate
Amd 2:2024 takes effect23 Aug 2025Point in timeExact

For a mixed system, Tesla's position is that only the Powerwall 3 requires a current listing. Existing Powerwall 2 units remain compliant, and new Powerwall 3 and Powerwall 3 Expansion units are listed and installed under a new connection agreement.

August 2026 webinar

The July notice advertised a webinar on Powerwall 2 and Powerwall 3 backwards compatibility for Tuesday 4 August 2026, 3:00pm to 3:30pm AEST, covering supported configurations and implications for customers and installers. The advertised date has passed; this record does not confirm current course availability.

Group certification

Perth Solar Warehouse and PSW Energy hold Tesla Certified Installer status, and Tesla requires mixed-system work to be completed by a certified installer.

Three practical points follow:

Sources

ShareLinkedInX